Carpet Cleaning Services in Sydney: 6 Effective tips to Get Your Carpet Clean In Sydney

Even the brightest carpet starts wearing out and start looking dull over the course of time. This is because of excessive dust, foot traffic, dirt grime and dust accumulation and the best way to get your carpet cleaning Melbourne nice and clean is:

Thoroughly Vacuum

You need to vacuum your carpets thoroughly before wet cleaning. Know that your carpets are the largest air filters so it is going to hold a lot of things like dirt, hair, dust, or even allergens. Therefore it is really important to come through first with a vacuum cleaner, remove that first layer as much as possible. That way when you come with the carpet cleaning Sydney and shampoo, you will be able to get to that really deeply embedded dirt and grime and remove that from the carpet too. If you do have more of a shaggy kind of high pile carpet we recommend that you vacuum the bed in a 360 degree pattern and what happen is these types of fibres like to fall down and that will trap dirt and things in your carpet. So if you only vacuum one way you might leave some of that behind, so by vacuuming in a 360 pattern you can remove as much.

Choosing the Right Cleaning Solution 

When it comes to picking up the right cleaning there are a variety of them on the market. We recommend consulting a professional carpet cleaning Sydney to find out which is the right cleaning solution for you.

Pre Treatment of the Carpet

Mixing up your carpet cleaning soap, your first thought might be to just grab it and throw it into your machine. What happens is it doesn’t give it enough time to work and do its job, plus this can lead to the carpet getting sticky and crunchy and leaving a residue behind. Instead try mixing it up in a pump up sprayer and this gives the soap time to work. When it comes to mixing remember the label is always the law, so follow the manufacturers’ instruction. Spray all the carpets down and let it sit for about five to ten minutes so that it can break down and dissolve all the deeply embedded dirt and grime that are stuck to the fibres. You can go heavier on the high traffic areas or areas that receive frequent foot traffics like hallways and entryways.

Pet Spots

If you have pets at home you might find a few spots to treat those a little different. You can use an enzyme based cleaner, not only does this break down the spot itself but it will also help with erasing odours.

Using a Carpet Cleaning Machine 

Now that the carpets are nicely treated there are a few things to note down when it comes to carpet cleaning and these things apply no matter what machine you might be using at home. The first thing is to fill your cleaning tank with water only and the reason is because if you add soaps or anything else it’s going to be left behind. So when we fill with water this not only infuses all the dirt and grime that sticks at the fibres but also the soap too. Go at a nice slow pace with your cleaning machine, the key here is to let it do the work.

The vacuum only functions and extract as much of the moisture only out of the carpet. If you do have an area that is really dirty and it didn’t clean up that great on the first pass you can repeat the process.

Drying the carpet

To complete this you can use a few fans or if your room has a ceiling fan make sure to turn that on as well. You also want to make sure that the home temperature is around 70 degree. So you can either turn on the AC or the heat may be even open.

If you are looking for a Carpet Cleaning in Geelong or any of the services mentioned above it is best advised to seek professional cleaning services for the best results.